Tabla de contenido
Publicidad
SETTING UP YOUR MACHINE
1. Wipe off excess oil in the needle plate and bed areas.
2. FOOT CONTROL
Push foot control plug into plug connector socket and connect the power cord plug to power
supply outlet.
3. POWER/ LIGHT SWITCH
Your machine will not operate unless the power/light switch is turned on. This same switch
controls both machine power and sewing light.
When leaving the machine unattended or servicing the machine, remove the power cord plug
from the power supply outlet.
4. OPENING FRONT COVER
To open front cover, pull it to the right and down towards you.
5. OPENING WORKING TABLE
To open working table, pull the release lever toward you with your right hand. Pull the cover
toward you to open.
I
Illustration
*
: Plug connector socket
II
*
: Power/light switch
*
III
: Release lever
IV
*
: Working table
V
*
: Front cover
10
Publicidad
Tabla de contenido
