SYM BOL
DESCRIPTION
SYMBOL
DESCRIPTION
General switch
Switch-off
Danger! Electricity
Switch-on
supply
10. TRANSPORT, HANDLING AND STORAGE
.
The machine is packed in a cardboard box bearing the symbols and indications for handling. It is subsequently
placed on a pallet and loaded on a container or wagon by means of an adequate forklift truck.
The machine must always be handled with the utmost care and caution.
Operators assigned to handling of the machine must be qualified and adequately trained.
For storage of the machine, use dry ventilated rooms and protect the machine with a tarpaulin.
The manufacturer accepts no liability for damages caused by operations that have been performed incorrectly..
11.1 Procedure for unloading the machine by means of a forklift truck
Step 1: unload the machine, still packed, from the lorry with the utmost caution
Step 2: rest the machine gently on the ground
Step 3: remove the packaging and gently raise the machine with the forklift truck,
being careful not to damage it, until the pallet can be removed
Step 4: rest the machine gently on a flat uniform surface as near as possible to its
final position.
11. PREPARATION OF PREMISES AND MACHINE INSTALLATION
The room in which the machine will be installed, like the various existing systems, must
comply with current local regulations and technical specifications.
Position the machine in a dry well-ventilated place in compliance with the local technical-
health regulations. In particular:
• Avoid positioning the machine near sources of heat (radiators, ovens, burners etc.) or
draughts. If this is not possible, the following minimum distances must be observed:
50 cm from coal or oil cookers and 50 cm from electric/gas cookers.
• To prevent inefficient refrigeration, avoid exposing the machine to direct sunlight.
• To ensure that the refrigeration works properly, leave a 15 cm gap around the entire
machine.
Carefully unpack the machine, removing the main cardboard box and then all the
packaging protection materials..
22
CT81900001
Rev.01 – 07/13