Neriox 121853 Instrucciones De Uso página 4

4
121853
DIGITAL DIAL GAUGE
OPERATING INSTRUCTIONS
Specification
Resolution: 0.01 mm / 0.001 mm
Measuring range: 12.7 mm / 30 mm / 50 mm
Operating temperature: 0 - 40°
Power: Lithium battery CR2032 / 3.0 V
Digital output: RS232
Features
Digital LCD display
Zero position (ZERO)
Measuring mode REL / ABS
PRESET (input preset value)
MAX / MIN function
Change mm / inch
Safety information
• Use the dial gauge only at the permissible operating temperature
• Protect the dial gauge against liquids and moisture
• Do not drop the dial gauge on the floor
• Protect the dial gauge against mechanical damage
• The dial gauge must be disposed of in compliance with the regulations
Key:
1. Battery compartment
2. Digital / analogue display
3. Data output interface
4. ZERO / ON button
5. ABS / PRESET button
6. in / mm button / measuring direction
7. TOL/SETTOL button
8. MAX/MIN
Comments:
In the following instructions, the meanings are as follows:
Briefly press → Tpress button for less than 2 seconds
Hold down → Tpress button for more than 2 seconds
7
6
5
Important information before using the dial gauge
1. Dirt on the measuring spindle affects its movement. If necessary,
clean the measuring spindle with a clean cloth. Under no circumstances
should oil be used to lubricate the measuring spindle.
2. If necessary, clean the housing with a dry cloth. In case of heavy soiling,
use a neutral-reacting solvent. Do not use organic solvents (such as benzine
or thinner) under any circumstances - this will damage the device and cause
it to malfunction.
3. Protect the data input port with the appropriate cover when not in use.
4. The dial gauge must be clamped in a suitable holding device
(e.g. dial gauge stand) with locating hole 8H7.
5. Unauthorised opening of the dial gauge will result in loss of the warranty.
1
8
2
3
4