Battery Operation; Radio Operation - Roadstar TRA-1957N Manual De Instrucciones

1 English
LOCATION OF CONTROLS
1. ON/OFF/VOLUME CONTROL
2. TUNING CONTROL
3. FM ANTENNA
4. HEADPHONE JACK
5. RADIO DIAL SCALE
6. BAND SELECTORS (MW/FM)
7. TONE CONTROL (HIGH/LOW)
8. BATTERY COMPARTMENT
9. SPEAKER
10. HANDLE
POWER SUPPLY

Battery Operation

• Open the Battery Compartment (8) at the back of the unit.
• Insert first 6 x UM-2 batteries following the polarity diagram shown inside
the battery compartment (not included)
• Batteries should be removed from the compartment if the unit is not to
be used for some time.
• Flat batteries should be removed from the unit to avoid leakage.
AC Power Operation
• Connect the AC Power Cord to your AC household mains outlet and
switch on the mains supply. Make sure the voltage is compatible.
• Before switching on make sure that the voltage of your electricity supply
is the same as that indicated on the rating plate.
• For your own safety read the following instructions carefully before at-
tempting to connect this unit to the mains.

RADIO OPERATION

1. Turn the VOLUME/OFF knob (1) until you hear a click.
2. Adjust the volume by turning the VOLUME control.
3. Turn the Tone Control (Hight/Low) for adjust the Tone (7).
4. Extend the telescopic antenna for FM Band. To optimize MW reception
turn horizontally the radio until reaching the best reception position.
5. Select the desired radio Band (FM/MW) with the Band selector (6).
6. Tune to the desired station with the Tuning knob (2).
7. To switch off the radio turn the volume knob counterclock-wise until a
click is heard.