Cleaning Products (Fig. 21); General Instructions; Cleaning Of The Outer Parts (Daily / Weekly); Clean The Internal Parts (Monthly) - Oscartielle POLARIS D Instrucciones De Uso

Polaris D - Mini Polaris D
English
The cleaning operations must include:
Step Denomination
Washing the
1
vehicle
Sanitization
2
3 Rinsing
4 Drying
19.1. Cleaning products
Best
DO NOT use
detergents

19.2. General instructions

The surfaces to be cleaned and the detergents and water used for cleaning must not exceed
a maximum temperature of 30°C.
Accurately dry with a soft cloth;
ATTENTION!
Fragile surfaces, glass. Dents, scratches, corrosion, wounds, broken glass
- DO NOT aim the jet directly on the varnished or plasticised surfaces
- DO NOT apply the products directly onto the surfaces to be cleaned
- DO NOT use steam cleaning equipment
- DO NOT apply too much force
- DO NOT bring the jet too close to the dirt, it can cause injury to the operator and
contaminate parts that have already been cleaned, as well as the environment.
- avoid detergents from coming into contact with nearby products.
ATTENTION!
Floor cleaning products. Fumes. Corrosion. Breathing impairment.
- avoid contact, inhalation.
Should you use pressure washers (Fig. 22):
- use LOW PRESSURE systems (max 30 bar) with suitable capacity to remove any dirt
present
- keep at a minimum distance of 30 cm from the surfaces to be cleaned .

19.3. Cleaning of the outer parts (Daily / Weekly)

Clean all external parts of the cabinet every week
See "General instructions" (cap.19.2.).

19.4. Clean the internal parts (Monthly)

Refer to chapters (cap.19.1.) and (cap.19.2.) and follow the steps given:
Step
1 completely remove all merchandise inside.
2 place the goods in a place at storage temperature.
60
roughing, removal of approximately 97% of the dirt)
cleaning+disinfection:
- cleaning: removal of visible dirt
- disinfection: removal of microorganisms remained after cleaning
(Fig. 21)
clean water at maximum temperature of 30°
soft cloth
mild and neutral detergents
with alcohol or similar products to clean the parts in methacyrlate (Plexiglas).
in powder
with granules
either acidic or alkaline (bleach, ammonia)
concentrates
with unknown chemical composition
abrasive products, chemical/organic solvents
abrasive sponges, scourers, sharp tools
aggresive solvents (acetic acid, citric acid etc.)
General
Action
05060144 01 22/08/2014