Fitting Instructions - S&P ARTIC-405 CN GR Instrucciones De Uso

FITTING INSTRUCTIONS

(Fig. 1)
1. Join the metal bar to the base and tighten it with the bolt.
2. Insert the motor support into the metal tube and fix it with the upper screw.
3. The foot of the base is height adjustable. To select the appropriate height, loosen the lower
fixing screw, then extend the bar upward until you obtain the desired height and tighten the
fixing screw firmly.
(Fig. 2)
1. Loosen the holding bolt on the back grill (clockwise) and the fan blade holding bolt (anti-
clockwise) from the motor shaft.
2. Mount the back protective grill on the motor head, ensuring that the 3 holes located in the
grill coincide with the three pins on the front part of the motor. Fix the grill to the motor using
the holding bolt for the back protective grill.
3. Place the fan blade on the motor shaft, adapting the slots in the central part of the fan blade
to the pins on the motor shaft and tighten the holding bolt for the fan blade.
4. Check the fan blade by turning it manually. Ensure that there is no friction with the safety
counter bolt. The fan blade must turn freely, if not, repeat the previous steps.
5. Mount the front protective grill by introducing the hook, located on the upper part of the
same, into the back protective grill. Unite the two gratings and press until they are well
joined within the plastic ring.
6. Close the security clip located on the bottom part of the front grill and tighten the screw.
OPERATION
The model has a four positions switch:
0 = Stop
1 = Low speed
2 = Medium speed
3 = High speed
OSCILLATION
The fan has a feature which allows the oscillation of the head from side to side of the basis. To
make the fan oscillate, you must press the oscillating switch. To stop the oscillation, just pull
the switch upward (Fig. 3).
INCLINACIÓN DEL CABEZAL
The ARTIC-CN fans have a multi-swinging head. To lean it you only have to press over the fan
adjusting it to the desired angle (Fig. 3).
9