Instalation; Arrangement Of The Lighting System; Arrangement Of The Pneumatic System; Classification According To The Atex Directive - Sagola DOBLE 250 Manual De Instrucciones

5
15
7
INCORRECT INSTALLATION OF THE MACHINE MAY
CAUSE DAMAGE TO PEOPLE, ANIMALS OR
OBJECTS. THE MANUFACTURER CANNOT BE
CONSIDERED RESPONSIBLE FOR THESE DAMAGES

6.1. ARRANGEMENT OF THE LIGHTING SYSTEM

The Client must make sure that there is suitable
lighting for the surroundings and that the lighting
conforms to the regulations in force. In particular,
the Client must arrange the positioning of lighting
that illuminates all the working area.
6.2. ARRANGEMENT OF THE PNEUMATIC
SYSTEM
The Client must arrange a line of filtered com-
pressed air supplied by a compressor that is
suitable for the consumption required. Do not use
compressed air that contains chemical products,
synthetic oil with organic solvents, salts or corro-
sive gases as they can cause damage or malfunc-
tioning. The line of compressed air must arrive up
to the supply points of the machine. If the com-
pressed air contains a large amount of moisture,
it may cause malfunctioning in the valves and in
the pneumatic components. Install a moisture
separator downstream from the compressor to
avoid this.
5. TECHNICAL SPECIFICATIONS
4
3
16
9
14 1
12
10

6. INSTALATION

6.3. CLASSIFICATION ACCORDING TO THE ATEX
DIRECTIVE
The machine conforms to the essential requisites
of the EU Directive 94/9/EC, better known as
ATEX ("Explosive Atmospheres"). It is classified
as group II category 3 letter G system. The
assessment procedures of conformity, carried out
by an internal factory check, allow the installa-
tion of the machine in surroundings where there
may be potentially explosive atmospheres due to
the presence of gas, fumes or mist.

6.4. POSITIONING

The Double 250 must be positioned in a well-ai-
red place.
The area must be equipped with all means provi-
ded for by the Italian Legislative each country
with reference to the health and safety of the
workers in the working environment.
Position the machine on the floor and make sure
that there is sufficient space around the machine
to carry out normal maintenance operations or
inspections.
- 18 -
6
13
11
2
8
1