Nolan N100-5 Special N-Com Seguridad E Instrucciones página 22

N100-5 / PLUS
approved helmet visors. However, the use of sunglasses makes it difficult to perform
emergency manoeuvres when the maximum visibility range of the helmet visor must be
quickly restored. Just think, for example, of what happens when you enter a tunnel or
when unexpected changes in environmental brightness occur. Thanks to its operating
mechanism, the VPS makes these operations much easier.
WARNING
- Use the special slider to activate/deactivate the VPS; do not deactivate the VPS
by handling it directly.
- The VPS can only be used during the day and under the environmental conditions
described before.
At night and/or in conditions of poor visibility, the VPS must be deactivated.
-
- Always check that the VPS is properly positioned according to different weather/
environmental conditions and/or the above-mentioned recommendations for use.
- We recommend using the VPS only and solely together with the approved stand-
ard visor, which has a transmittance value greater than 80%.
- The VPS does not replace the protection guaranteed by the visor.
- Always make sure that the VPS is clean and that it is operating properly in order to
avoid scratches and/or anomalous wear on it every time it is activated.
- As for VPS and visor maintenance and cleaning operations, please refer to the
appropriate section in the helmet user's manual.
- The VPS scratch resistant/fog-resistant treatment highly reduces fogging. Pro-
tracted periods of adverse weather and/or environmental conditions might cause
fogging and/or formation of condensation on the VPS, which entails a reduction of
visibility and/or sharpness of vision: in this case, deactivate the VPS.
- In case of rain, the direct contact of raindrops with the scratch resistant/fog-resist-
ant treated VPS quickly reduces sharpness of vision, thus causing scarce visibility:
in this case, deactivate the VPS.
- The special VPS fog-resistant treatment is usually sensitive to high temperatures
or heat sources. In this case, contaminations caused by contact with other mate-
rials might occur. These contaminations will cause marks and stains to develop.
In these cases (e.g. when the helmet is kept in the top case on hot days), it is
recommended to make sure the VPS is not touching other materials.
3 DISASSEMBLY
3.1 Open the helmet chin guard and lower the VPS completely (see instructions
above).
3.2 Hold the left lateral part of the sunscreen and pull it toward the outside of the
helmet (Fig. 13).
3.3 Repeat the same operation on the right side of the helmet.
4 ASSEMBLY
4.1 Open the helmet chin guard and move the side slider until it stops (see instructions
above) (Fig. 11).
4.2 Insert the sunscreen left end into the left side guide until it is hooked in the shell
housing (Fig. 13).
4.3 Repeat the same operation on the right side of the helmet.
22
INSTRUCTIONS FOR USE