General Power Tool Safety Warnings - Maktec MT412 Manual De Instrucciones

ENGLISH (Original instructions)
1. Wing bolt
2. Base
3. Edge of the front base
4. Lock button/Lock-off button
5. Switch trigger
SPECIFICATIONS
Wheel diameter
Max. cutting capacities
No load speed (min
Overall length
• Due to our continuing programme of research and development, the specifications herein are subject to change without
notice.
• Specifications may differ from country to country.
• When used with 105 mm diameter wheel, max cutting capacities are somewhat smaller than that for 110 mm diameter
wheel above shown.
• Weight according to EPTA-Procedure 01/2003
Intended use
The tool is intended for cutting in brick, concrete and
stone without the use of water.
Power supply
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and can
only be operated on single-phase AC supply. They are
double-insulated and can, therefore, also be used from
sockets without earth wire.
For public low-voltage distribution systems of
between 220 V and 250 V.
Switching operations of electric apparatus cause voltage
fluctuations. The operation of this device under
unfavorable mains conditions can have adverse effects to
the operation of other equipment. With a mains
impedance equal or less than 0.43 Ohms it can be
presumed that there will be no negative effects. The
mains socket used for this device must be protected with
a fuse or protective circuit breaker having slow tripping
characteristics.
General Power Tool Safety
Warnings
WARNING Read all safety warnings and all
instructions. Failure to follow the warnings and
instructions may result in electric shock, fire and/or
serious injury.
Save all warnings and
instructions for future reference.
4
Explanation of general view
6. Hex wrench
7. Outer flange
8. Wrench
9. Inner flange
10. Diamond wheel
Model
-1
)
Net weight
Safety class
110 mm
32.5 mm
CUTTER SAFETY WARNINGS
ENE070-1
1. Read all safety warnings, instructions,
ENF002-2 illustrations and specifications provided with this
power tool. Failure to follow all instructions listed
below may result in electric shock, fire and/or serious
injury.
2. Always use guard provided with the tool. The
guard must be securely attached to the power tool
and positioned for maximum safety, so the least
amount of wheel is exposed towards the operator.
ENF100-1
The guard helps to protect operator from broken
wheel fragments and accidental contact with wheel.
3. Use only diamond cut-off wheel for your power
tool. Just because the accessory can be attached to
your power tool, it does not assure safe operation.
4. The rated speed of the wheel must be at least
equal to the maximum speed marked on the power
tool. Wheels running faster than their rated speed can
break and fly apart.
5. Always use undamaged wheel flanges that are of
correct diameter for your selected wheel. Proper
wheel flanges support the wheel thus reducing the
possibility of wheel breakage.
GEA010-1
6. The outside diameter and the thickness of your
wheel must be within the capacity rating of your
power tool. Incorrectly sized wheels cannot be
adequately guarded or controlled.
7. The arbour size of wheels and flanges must
properly fit the spindle of the power tool. Wheels
and flanges with arbour holes that do not match the
mounting hardware of the power tool will run out of
balance, vibrate excessively and may cause loss of
control.
8. Do not use damaged wheels. Before each use,
inspect the wheels for chips and cracks. If power
11. Hex bolt
12. Limit mark
13. Screwdriver
14. Brush holder cap
MT412
125 mm
40 mm
12,000
216 mm
3.0 kg
/II
GEB025-2