7.1
Maintenance plan
i
Before beginning service, disconnect from power. The work area around the lift is to be secured against
unauthorised use.
Visual
Spray
inspection
Time frame
Position
Type of
maintenance
12
1
11
2
10
365 x / 12
9
3
4
8
5
7
6
12
1
11
2
10
365 x / 12
9
3
4
8
5
7
6
12
1
11
2
10
1 x / 12
9
3
4
8
5
7
6
12
1
11
2
10
1 x / 12
9
3
4
8
5
7
6
74
Oil
Lubricate
Check the polymer overlays and replace if required.
Model and information signs, labels, brief operating instructions,
safety stickers and warning information are to be cleaned and ex-
changed if damaged.
Check all available safety devices for function.
e.g.: CE stop, warning signal, blocking etc.
Exchange if damaged.
• Free the piston rod of the lifting cylinder of sand and dirt.
• Check the wiper for damage.
• Moving parts such as joint bolts and DU bearings, sliding pieces, slid-
ing surfaces and rollers are to be cleaned and checked for wear,
exchange if required.
• Lubricate all lubrication nipples with an acid-free multi-purpose
grease. Do not over-lubricate.
• Check the condition and function of the driving ramp.
• Check the condition of the cement floor.
• Check the torque of the fastening anchor. Also see the assembly
protocol.
• The condition and function of the load suspension means are to be
checked.
• Check the condition and function of all available safety devices.
All weld seams must have a visual inspection. Stop the system and
contact the manufacturer if there are cracks or breaks in weld seams
of the lift.
Clean with
Clean
compressed
air
Maintenance plan
OPI_JUMBO LIFT 3500 NT_V3.1_DE-EN-FR-ES-IT
Inspect