Fault In Water Flow; Removing The Appliance - Gaggenau CM470711 Instrucciones De Instalación

Fault in water flow

To ensure an adequate water flow, the filter in the
AquaStop should be cleaned regularly.
1 Turn off the tap.
2 Unscrew the water inlet hose with the AquaStop
from the tap.
3 Clean the filter with a small brush.
Important: Do not remove the filter under any
circumstances.
4 Screw the water inlet hose with the AquaStop to the
tap.
5 Slowly turn on the tap so it is fully open.
6 Check the connections and water inlet hose for
leaks.
If the appliance is cleaned and maintained regularly, this
will avoid faults.
16

Removing the appliance

1 Run emptying program. See instruction manual.
2 Turn off the tap.
3 Disconnect the mains plug.
4 Remove the water inlet and water outlet hoses.
5 Remove all screws. See installation.
6 Gently pull out appliance.
7 Pull the appliance out from the cabinet.