LaserLiner SmartCross-Laser Manual De Instrucciones página 10

The transport restraint must be released for horizontal
and vertical levelling. The LED (2) shows a permanent
! green light. The laser lines flash and the LED (2) lights
red as soon as the device is outside the automatic
levelling range of 5°. Position the device such that it is
within the levelling range. The LED (2) switches back
to green and the laser lines stop flashing (steady light).
3 Slope mode
Do not release the transport restraint, set the ON/OFF switch
to „OFF". Select and switch on the laser with the selection
button. Sloping planes can now be measured. This mode
cannot be used to perform horizontal or vertical levelling as
the laser lines are no longer aligned automatically. The LED
lights constantly red.
LASER
4 Hand receiver mode
Optional: Working with the laser receiver RX
Use an RX laser receiver (optional)
to carry out levelling at great
distances or when the laser lines
are no longer visible. To work
with a laser receiver, switch the
line laser to hand-held receiver
mode by keeping button 1
(handheld receiver mode on / off)
pressed. The laser lines will now
pulsate with high frequency, making the laser lines darker.
The laser receiver can detect these pulsating laser lines.
!
Observe the laser receiver's operating instructions
for line lasers.
10
EN
LASER LASER LASER LASER