Quick Start - Single System Setup - Samson Concert 88x Manual De Propietario

Quick Start - Single System Setup

In order for your wireless system to work correctly, both the receiver and transmitter must be set
to the same channel.
Follow this basic procedure for setting up and using your Concert 88x wireless system:
Physically place the CR88x receiver where it will be used, and extend the antennas vertically.
The general rule of thumb is to maintain "line of sight" between the receiver and transmitter so
that the person using or wearing the transmitter can see the receiver.
With the CR88x powered off, connect the included power adapter. Turn the CR88x on
momentarily to confirm that the unit is receiving power. You'll see the LED display light up.
Then turn the CR88x power off.
With your amplifier or mixer off and volume control
all the way down, connect the CR88x receiver
output jack to the mic or line level input of a mixer
7. Install batteries
or amplifier using the balanced XLR output or
unbalanced 1/4" line level output. Turn the Level
knob on the CR88x completely counterclockwise,
then turn its power on.
With the transmitter powered off, install two fresh AA
batteries into the CB88 beltpack or CH88 handheld
transmitter. Leave the battery compartment open.
12
6. Press Select button to change channel
3. Plug in receiver
4. Turn on receiver
7. Install batteries
8. Press button on transmitter to turn on
4. Turn on receiver
5. Plug receiver into audio system
8. Turn on belt pack transm
7. Install batteries