Metrohm 784 KFP Titrino Instrucciones Para El Uso página 78

784 KFP Titrino
3.2.2.32. UserMeth.List.1.Name
UserMeth.List.1.Mode
UserMeth.List.1.Quantity
UserMeth.List.1.DosUnit
UserMeth.List.1.Bytes
UserMeth.List.1.Checksum
for each method
List of the methods in the user method memory with the following characte-
ristics:
.Name: Name of the method
.Mode: Mode
.Quantity: Measured quantity
.DosUnit: Buret of the method
.Bytes: Number of bytes of the user memory used by the method
.Checksum: Checksum of the method, see 3.2.2.61.
3.2.2.33. Config.Monitoring.Validation.Status
Config.Monitoring.Validation.Interval
Config.Monitoring.Validation.Counter
Config.Monitoring.Validation.ClearCount
Monitoring of validation.
.Interval: Time interval in days for validation.
.Counter: Time counter in days since last validation.
.ClearCount: Clears the above counter.
3.2.2.34. Config.Monitoring.Service.Status
Config.Monitoring.Service.Date
Monitoring of service interval.
3.2.2.35. Config.Monitoring.DiagRep
Printing of system test report after each switching on of the Titrino.
3.2.2.36. Config.PeriphUnit.CharSet1
Config.PeriphUnit.CharSet2
Selection of the character set and the graphics control characters for COM1
resp. COM2 of the Titrino.
IBM means the IBM character set following character set table 437 and IBM
graphics control characters. Select 'IBM' for work with the computer.
3.2.2.37. Config.PeriphUnit.RepToComport
Selection of COM of the Titrino where manually triggered reports should be
outputted.
3.2.2.38. Config.PeriphUnit.Balance
Selection of the balance type.
3.2 Remote control commands
1...365...9999
YYYY-MM-DD
Epson, Seiko, Citizen, HP, IBM
Sartorius,Mettler,Mettler AT,
AND,Precisa
read only
read only
read only
read only
read only
read only
ON, OFF
0...9999
$G
ON, OFF
ON, OFF
1, 2, 1&2
73