Metrohm 784 KFP Titrino Instrucciones Para El Uso página 86

784 KFP Titrino
3.2.2.68. Info.ActualInfo.Assembly.Counter.V
Info.ActualInfo.Assembly.Counter.Clear
$Q sends the volume. With the function &Info.Assembly.Counter.Clear $G,
the volume counter is set to zero.
3.2.2.69. Info.ActualInfo.Assembly.Meas
$Q sends the current measured value from the assembly.
3.2.2.70. Info.ActualInfo.Titrator.CyclNo
Info.ActualInfo.Titrator.V
Info.ActualInfo.Titrator.Meas
Info.ActualInfo.Titrator.dVdt
Info.ActualInfo.Titrator.dMeasdt
Info.ActualInfo.Titrator.dMeasdV
Info.ActualInfo.Titrator.T
$Q sends the current values in the following formats:
CyclNo
V(mL)
Meas:
Ipol (mV)
Upol (µA)
dVdt (µL/s)
dMeasdt
Ipol (mV/s)
Upol (µA/s)
dMeasdV (mV/µL)
NV: Not Valid.
OV will be sent for "overrange".
A time frame can be set up from the cycle number and the cycle time (see
3.2.2.75). The cycle number is set to 0 at the start of a method and it is in-
cremented until the end of the method.
3.2.2.71. Info.ActualInfo.MeasPt.Index
Info.ActualInfo.MeasPt.X
Info.ActualInfo.MeasPt.Y
Info.ActualInfo.MeasPt.Z1
Info.ActualInfo.MeasPt.Z2
Info.ActualInfo.EP.Index
Info.ActualInfo.EP.X
Info.ActualInfo.EP.Y
$Q sends the last entry into the measuring point list (.MeasPt) or the last en-
try into the list of EP's.
3.2 Remote control commands
KFT
127
1.2345
–345.6
–12.5
2.5142
0.7957
0.7957
10.6326
read only
$G
read only
read only
read only
read only
read only
read only
read only
read only
read only
read only
read only
read only
read only
read only
read only
read only
81