Baby auto Zarauz Con 123 Deluxe AB710A Manual De Uso página 22

5. Finish tightening the vehicle seat belt by pulling the diagonal
shoulder belt upwards until there is no slack and the child seat is
securely installed (3.8).
6. Tighten the lap belt and diagonal shoulder belt, then place the red
safety clip on the diagonal shoulder belt tongue as near to the
vehicle anchor point as possible without touching it! (3.9, 3.10, 3.11
and 3.12).
When the seat is being used for group 1, the belt should go under the
headrest and this should be in its lowest position.
Ensure that the belt has no slack.
4. HOW TO INSTALL THE CHILD CAR SAFETY SEAT. GROUP 2 & 3.
WARNING
Before installing the seat it is necessary to remove harness straps,
crotch straps and lap straps as shown in Chapter 6.
1. According to the child's height the headrest can be adjusted up or
down. Place your hand on the headrest and press the lever while
pulling the seat down with the other hand so it does not move (4.1).
2. Place the child seat on the seat of the vehicle, ensuring it is pressed
firmly against the back of the vehicle seat (4.2).
3. Place the child in the child car safety seat(4.3).
4. Fasten the belt, ensuring that the lap belt goes through
under both armrests and that the diagonal shoulder belt passes
through B
vehicle anchor point. You will hear a "click" when this is properly
fastened. Ensure that the belts are not twisted and tighten by
pulling the diagonal shoulder belt upwards (4.4).
It is advisable to continue using the seat backrest until the child's
height exceeds the headboard.
22 Child restraint system
guide and J guide under the armrest that is next to the
Use Group 2 & 3 only from approx. 4
to 12 years of age (15-36 kg)
J guide
ZARAUZ CON