Intrusion (Burglary) Alarm Continuous Siren; Alarm Memory - DSC WTK5504 Manual Del Usuario Y Operador

Troubles
Time and Date
Trouble
Alternate
Communicator
Trouble
Alarms
When Alarm Sounds
The system can generate 3 different alarm sounds:
• Temporal/pulsed siren = Fire Alarm
• 4 beeps, 5-second pause, 4 beeps = Carbon Monoxide Alarm
• Continuous siren = Intrusion (Burglary Alarm)
NOTE: The priority of signals is fire alarm, carbon monoxide alarm then burglary alarm.
Fire Alarm Pulsed Siren
Follow your emergency evacuation plan immediately!
If the fire alarm was accidental (e.g., burned toast, bathroom steam, etc.), enter your access code to silence the
alarm. Call your central station to avoid a dispatch.
Wireless Carbon Monoxide Alarm
Activation of your CO alarm indicates the presence of carbon monoxide (CO), which can be fatal. During an alarm, the
red LED on the CO detector flashes rapidly and the buzzer sounds with a repeating cadence of: 4 quick beeps, 5-sec-
ond pause, 4 quick beeps. Also during an alarm, the siren connected to the control panel produces a repeating cadence
of 4 quick beeps, 5-second pause, 4 quick beeps. The keypad will also provide audible and visual indication of the CO
alarm.
If an alarm sounds:
1. Operate silence button.
2. Call emergency services or your fire department.
3. Immediately move outdoors or to an open door/window.
WARNING: Carefully review your Carbon Monoxide Installation/User Guide to determine the
necessary actions required to ensure your safety and ensure that the equipment is operating cor-
rectly. Incorporate the steps outlined in the guide into your evacuation plan.

Intrusion (Burglary) Alarm Continuous Siren

If you are unsure of the source of the alarm, proceed with caution!
1.If the alarm was accidental, enter your access code to silence the alarm. If the alarm system is disarmed
within the programmed Abort window (check with the installer if this option has been enabled on your system
and what transmitter delay time is programmed), no alarm transmission to the Central Station will occur.
2. Following the Abort window is a 5-minute Cancel window, during which a user can enter their access code to
cancel a previously transmitted alarm. A cancel signal will be transmitted to the Central Station and the screen
will indicate "Communications Cancelled". Call your Central Station to avoid a dispatch.

Alarm Memory

When an alarm occurs, the Memory indicator will turn on.
To view which sensor(s) generated the alarm, press Alarm
displayed (e.g. Zone 01).
Use the [<][>] scroll keys to view the sensors in alarm memory.
Press Back or Home to exit. To clear the memory, arm and disarm the system.
If an alarm sounded while armed, the keypad will automatically go to alarm memory when you disarm the system. In
this instance, you should approach with caution, as the intruder may still be within the building/premises.
Sensor Reset
Home > More > Functions > Outputs > Reset
Certain sensors, after having detected an alarm condition, require a reset to exit the alarm condition (e.g., glass break
sensors, smoke detectors, etc.). Ask your alarm company if this function is required on your system.
To reset the detectors, press Reset (or
reset, it may still be detecting an alarm condition. If the sensor reset is successful, the alarm is cancelled. If unsuccess-
ful, the alarm will reactivate or continue.
7
Comments/Further Options
If complete power was lost (AC and Battery), the time and date need to be
reprogrammed.
• SIM Lock
• GSM
• Ethernet
Command O/P #2
• Receiver
• Supervision
• Config SMS
. The sensor number where the alarm occurred will be
if the installer did not program a label). If a sensor fails to
Action
Reprogram time
& date
Call for service.
For Ethernet
trouble, check
LAN
connections.