LOTRONIC PLUTON30-WASH Manual De Instrucciones página 3

Features
Two moving heads in the same housing. The white 30W LED produces a Spot effect and the 6x 12W 6-in-1 LED
create a Wash effect.
4 or 20 DMX channels
•
Auto, DMX, master-slave and music control
•
• 8 built-in programs, music-controlled in DMX mode
• Scan position memory
• 7-color wheel + open white, half-color, rainbow-flow effect
7-gobo wheel + open, gobo-flow & gobo-shake
•
• 10° beam
• Linear dimmer 0-100%
Specifications
Power supply ........................................................................................ 100-240Vac 50/60Hz
Consumption ................................................................................................................ 140W
Light source .................................................................................... 1x white 30W LED (spot)
............................................................................................ 6 x 12W RGBWA-UV 6-in-1 LED
Pan/Tilt ............................................................................................ 540°/190° hi/low speed
Strobe ......................................................................................................................... 0-23Hz
Dimensions ............................................................................................ 245 x 145 x 345mm
Weight ......................................................................................................................... 4,02kg
Mounting
ORIENTATION
This fixture may be mounted in any position
provided there is adequate room for ventilation.
RIGGING
The LED moving head provides a unique mounting
bracket assembly that integrates the bottom of
the base, the included 'omega bracket' and the
safety cable rigging point in one unit (see the
illustration on the right).When mounting this
fixture on a truss, be sure to use an appropriate
clamp with the included omega bracket using a
M10 screw fitted through the center hole of the
'omega bracket'. As an added safety measure, be
sure to attach at least one properly rated safety
cable to the fixture using one of the safety cable
rigging points integrated in the base assembly.
SETUP
Disconnect the power cord before replacing a fuse and always replace with the same type fuse.
Fixture Linking
You will need a serial data link to run light shows of one or more fixtures using a DMX-512 controller or to run
synchronized shows on two or more fixtures set to a master/slave operating mode. The combined number of
channels required by all fixtures on a serial data link determines the number of fixtures that the data link can
support.
©Copyright LOTRONIC 2018 PLUTON30-WASH Page 3