Ottobock 50K4-1 Agilium Freestep 2.0 Instrucciones De Uso página 14

3) Verify that the lateral contact is at least 3 cm below the fibular head. If
the lateral contact extends closer than 3 cm to the fibular head, select
the next smaller brace size.
INFORMATION: If the 50K4-1 Agilium Freestep 2.0 does not fit due
to the calf circumference, the 50K4 Agilium Freestep Classic can
be used.
5.2 Adaptation
CAUTION
Incorrect alignment, assembly or adjustment
Injury and damage to product components
► Observe the alignment, assembly and adjustment instructions.
► Work on the product may only be carried out by qualified personnel.
NOTICE
Improper molding or application
Damage to the product due to overloading of the material and improper fit
of the product due to breakage of load-bearing components
► The product may only be molded by qualified personnel.
► Do not make any improper changes to the product.
► Always apply the product according to the information in the instruc­
tions.
Adjusting the distance from the brace joint to the ankle
1) Mark the foot contour on the foot component. The pivot point of the
brace joint has to line up with the pivot point of the ankle joint (see
fig. 2).
2) Trim the sole to fit the inner contour of the shoe (see fig. 3). Take the foot
contour into account in doing so.
3) Round the edges of the foot component. Use a silicone cone for this pur­
pose.
4) Option: Bend the foot stirrup
Bend the foot stirrup with a bending iron.
Optional: Gluing on the insole
1) Roughen the top of the foot component.
2) Apply adhesive to the roughened foot component and glue on the insole.
Note that the distance between the brace ankle joint and the ankle joint
is reduced.
14