Mounting The Wall Bracket - Ondal Acrobat 2000 Instrucciones De Montaje

2 Fixtures
3

Mounting the wall bracket

750 / 950
750 / 950
2 Fixtures
Please be sure to observe the safety information in section 1
2.1 Load data
Figure 1
The choice of fixtures according to the following table and the safe execution of
thefixture is up to the person responsible for installation.
WARNING – Note load data:
The static load data (rounded up) of the wall arm with the appliance
mounted on it can be found in the table below.

The operating forces must be added to the static load data.

The stipulated regional safety factors, but at least factor 3, must
be takeninto account.

The applicable regional building provisions must be observed.
Maximum
Extension arm
length
[mm]
750
Figure 2
950
2.2 Fixtures
Due to the varying nature and load-bearing capacity of walls, it is not possible to
definitively recommend particular dowels. Find out from fixture manufacturers
about theuse of suitable, type-approved fixtures.
3 Mounting the wall bracket
Please be sure to observe the safety information in section 1.
3.1 Installation height and operating range
Mountend
appliance
Typ M41
Typ S32 / S32L
* = recommended installation height
-Figure 01
Maximum Bending
appliance load moment
[N] MB [Nm]
120 340
120 390
Lower drill hole H
[mm]
2030
2080 *
2150
2030
2080 *
2150
15
.
Vertical weight
FG [N] required to
240
245
-Figure 02
R [mm] R [mm]
Extension arm 750 Extension arm 950
1810
1790
1750
1630
1600
1550
GB
D
D
D
Force
pull out
dowel
FD[N]
1800
2100
2010
1990
1950
1830
1800
1750