Preparation; Required Tools And Material; Mounting The Light - LIVARNO LUX 14117201L Instrucciones De Montaje, De Uso Y De Seguridad

Safety / Preparation / Mounting the light
Avoid the risk of fatal injury
from electric shock
Ensure that a qualified electrician, or a person
trained to carry out electrical installations,
performs the electrical installation.
We assume no liability for property damage or
personal injury due to improper handling or
failure to observe the safety notices!
Never use the light if any defects have been
identified.
Prior to installation, remove the fuse or switch
off the circuit breaker (0 setting) in the fuse box.
Ensure that the light does not come into contact
with water or other liquids under any circum-
stances.
Prior to installation, ensure that the mains volt-
age on site corresponds with the operating
voltage required for the light (see „Technical
Data").
Be sure not to damage any wires during instal-
lation.
Never open any of the components of the elec-
trical equipment or insert any objects into the
same components. This will pose a risk of fatal
injury from electric shock.
Model 14117201L / 14117206L:
The length of the pendant light is not adjustable.
Prevent fire and
injury hazards
CAUTION! DANGER OF BURNS DUE
TO HOT SURFACES!
To prevent burns, be sure the light is switched
off and cooled down before touching it.
Do not attach the light to a damp or conduc-
tive substrate.
The LED light is not dimmable.
Do not look directly into the light source (lamp,
LED, etc.). Do not look into the light source
(lamp, LED, etc.) with an optical instrument
(e.g. magnifier).
16 GB/IE
FIRE HAZARD!
0.3m
Install the light so that it is at least 0.3 m away
from the material to be illuminated (Model
14117201L, 14117206L).
This light is only suitable for indoor
use in dry and enclosed spaces.
For your safety
Install the light so it is protected from moisture,
dirt and excessive heating.
Always be attentive! Always pay attention to
what you are doing and use common sense.
Never use the light if you are having difficulty
concentrating or do not feel well.
Familiarise yourself with all instructions and dia-
grams in this manual as well as with the light it-
self before use.

Preparation

Required tools and material

The tools and materials specified are not included.
This information and these values are non-binding
and are only provided as a reference. The nature
of the material is determined by the individual local
conditions.
- Pencil/marking tool
- Voltage tester
- Screwdriver
- Electric drill
- Drill (approx ø 6 mm)
- Side cutting pliers
- Ladder

Mounting the light

RISK OF ELECTRIC SHOCK!
Prior to installation, remove the fuse or switch off
the circuit breaker in the fuse box (Position 0).