Special Product Features; Initial Operation; Use - Metabo STA 18 LTX Instrucciones De Manejo

ENGLISH
ENG
19 Screw for adjusting the footplate
20 Curved support plate indicating preset cutting
angle
* depending on features

5 Special Product Features

• Metabo tool-free "Quick" saw blade tool change
system; sturdy clamping lever made of diecast
aluminium
• Integral LED working light for illuminating the
cutting line

6 Initial Operation

6.1 Introduce the anti-splintering footplate
insert into the protective plate (5).
Danger of injury due to the sharp jigsaw
blade. Remove the saw blade before fitting
(5) the anti-splintering footplate insert.
Turn the machine over so that the footplate faces
upwards. Insert the anti-splintering footplate from
the front, ensuring the following:
• The smooth side of the footplate faces upwards.
• The slot is facing to the rear.
If you wish to work with the protective plate
attached (see chapter Accessories 10), fit the
anti-splintering footplate insert in the protective
plate.
6.2 Inserting the saw blade
Danger of injury due to the sharp jigsaw
blade. After stopping work, the jigsaw blade
may still be hot. Wear protective gloves.
Use a saw blade that is suitable for the material
being sawn.
- Turn the clamping lever (1) forwards to the stop
and hold in place.
- Insert the saw blade (4) up to the stop. Ensure
that the saw teeth are facing forwards and the
blade is seated correctly in the groove on the
saw blade support roller (3).
- Release the clamping lever (1). (It returns to its
initial position by itself. The saw blade is now
securely tightened).
6.3 Removing the saw blade
- Turn the clamping lever (1) forward until the stop;
the saw blade is ejected as a result of spring
force.
Caution: Be careful not to point the jigsaw at
anyone when removing it.
8
6.4 Diagonal cuts
Remove the protective plate (6). This part cannot
be used for making diagonal cuts.
- Slacken the screw (19).
- Slid the footplate (7) forwards slightly and turn.
- The preset angle is indicated on the curved
support plate (20) on the footplate. Adjust to
different angles using an angle gage.

7 Use

7.1 Battery pack
Charge the battery pack before use (16).
If performance diminishes, recharge the battery
pack.
"Li-Power" li-ion battery packs have a capacity
and signal indicator: (18)
- Press the button (17), the LEDs indicate the
charge level.
- If one LED is flashing, the battery pack is almost
flat and must be recharged.
7.2 Removing and inserting the battery
pack
To remove:
Press the battery pack release (15) button and pull
the battery pack (16) forwards.
To fit:
Slide in the battery pack (16) until it engages.
7.3 Chip blower
Optional blower for a clear view of the cutting line.
Turn the control lever (10) on the right-hand side of
the machine.
O = Chip blower on
X = Chip blower off
7.4 Adjusting the pendulum motion
Set the required pendulum motion using the
adjustment lever (13).
Position "0" = pendulum motion is switched off
. . .
Position "3" = maximum pendulum motion
See page 2 for recommend setting values.
The best way to determine the ideal setting is
through a practical trial.