Use Of The Machine; Machine Start And Water Supply; Heating - Bezzera BZ02 PM Manual De Instrucciones

English

5 USE OF THE MACHINE

The general view of the machine is on page 27 of this booklet.

5.1 Machine Start and Water Supply

Fill the wather tank, S version (fig.1; pos. 9).
Turn on the water supply tap (R version).
Press the switch ON/OFF (fig.1; pos. 1).
Automatically the water is supplied to the boiler. During this operation, the lights 11
and 12 on the control panel are off.
At the end of the water supply, the lights 11 e 12 will be on.
Should the lights be off after the water supply, turn on and off the switch ON/OFF till
the lights 11 and 12 light up.

5.2 Heating

In order to have the right temperature for the machine, turn the steam knob (fig. 1; pos.
4) and let out 2 or 3 times the steam into the drain tray.
The green light (fig. 1; pos. 12), if on, points out the resistance activation.
The yellow light (fig. 1; pos. 11), if on, points out that the machine is in working order;
if off, it means that the water level in the boiler is not enough.
Caution:
A safety device allows to stop the pump after 120 seconds if the water minimum level
is not supplied to the boiler. The machine, as alarm signal, turns off the yellow light
(fig. 1; pos. 11).
BZ02PM_BZ02DE 31
cod.9941038 ed.02/04 rev.00