5....-05-KA 2887
GB
1. Open the water tank lid.
2. Now fill with enough fresh cold water for the desired number of cups. You can
read the level on the water level display. Do not overfill the appliance (max. 12
cups).
3. Close the water tank lid.
4. Swing the filter the left. Insert a paper filter (size 1x4) in the filter funnel and fill
with ground coffee (approx. 1 teaspoon for two cups). Lock in the filter until it
snaps into place.
5. Place the coffee pot on the hot plate.
6. Shift the switch to position I. (The LED in the switch lights up). The brewing pro-
cess lasts approximately 10-15 minutes. At the end of the brewing process,
please wait until the filter too is empty. Once there is no more coffee in the pot,
the can be removed.
7. The appliance is equipped with a drop stop that prevents that the coffee drips
on the hotplate when the can is removed. Put the can back into place and the
stop is activated again.
If you wish to keep the remaining warm, the switch must be left in the I position.
The hotplate keeps the coffee warm until the switch is shifted to O.
Aroma selection switch
To select the aroma, change the setting between "strong coffee" (
"weak coffee" (
Switching Off
The machine is switched off when the switch is in the O position.
(The LED in the switch is off.)
In order to extend the service life of the appliance, it is highly recommended to
decalcify the appliance on a regular basis. The decalcification is necessary if the
brewing time increases substantially. Use only a commercially available citrus acid-
based decalcifier.
Before cleaning the machine you should always remove the mains lead and wait
until the machine has cooled down. The machine should only be cleaned with a
slightly damp cloth. Remove the filter on the appliance by pulling the latch on the fil-
ter insert. The coffee pot and the filter pad should be cleaned by rinsing in cold
water.
24
08.04.2004
16:40 Uhr
Preparing the coffee
) according to taste.
Descaling
Cleaning
Seite 24
) and