BABYTREND HC38 Manual De Instrucciones página 5

ASSEMBLY
TO ASSEMBLE BOOSTER SEAT
• ONLY approved ™ products can
SNAP TECH
be used on the frame.
5) • Slide Footrest posts into the front of the
Seat until it clicks into place (Fig. 5a).
• Connect the Seat and lock into place (Fig.
5b). Pull up and make sure it's locked
firmly in place before use (Fig. 5c).
TO ATTACH TRAY
WARNING:
check that the high chair is
locked in the open position
before using.
WARNING:
is not designed to hold the
child in the chair. The child
must be secured in the high
chair at all times by the
5-point restraining system,
either in the reclining, semi-
reclining or upright position.
Do not force the tray against
the child.
6) • To attach the Tray, line up the Grooves
on the bottom of the Tray with the
armrests of the high chair. Squeeze the
front release handle and slide the Tray
onto the armrests (Fig. 6a).
7
Copyright © 2019, Baby Trend Inc., All Rights Reserved. Todos los derechos reservados. Tous droits réservés.
Fig. 5a
Always
Fig. 5b
The tray
Fig. 5c
The Tray has a 3-position adjustment.
To adjust the position, squeeze the front
release handle located underneath
the Tray and reposition the Tray to the
desired position. Release the Tray's
handle. Make sure the Tray is securely
locked in its new position before use.
ATTENTION:
Never leave the tray in a position where the
warning signs are visible (Fig. 6b).
TO ATTACH INSERT TRAY
7) • The dishwasher safe Tray Insert snaps
onto the High Chair Tray and is held in
place by tabs on the sides of the Tray.
When installing the Tray Insert make sure
that it snaps into place to prevent the child
from removing the Tray Insert. To remove
Insert unsnap tabs from the Tray (Fig. 7a).
• The Tray may be stored on the back legs
of the High Chair. Align the holes in the
rear of the tray with the small pegs on the
back legs (Fig. 7b).
Groove
Release Handle
Fig. 6a
Copyright © 2019, Baby Trend Inc., All Rights Reserved. Todos los derechos reservados. Tous droits réservés.
ASSEMBLY
Fig. 6b
Fig. 7a
Fig. 7b
8