BABYTREND HC38 Manual De Instrucciones página 9

OPERATION
• Wrap the back straps around the back of
the chair. Buckle the straps making sure
you hear the buckle *CLICK* closed
(Fig. 20c).
• Pull the free ends of the strap to firmly
tighten the Booster Seat to the chair
(Fig. 20d).
• Wrap bottom straps around the bottom of
the chair. Buckle the straps making sure
you hear buckle *CLICK* closed (Fig.
20e).
• Pull the free ends of the straps to firmly
tighten the Booster Seat onto the chair
(Fig. 20d).
• Check that the Booster is tightly installed
by attempting to move the Booster Seat
from side-to-side and up. The Booster
Seat should not move more than 1 inch.
TO REMOVE BOOSTER SEAT
FROM CHAIR
21) • Unbuckle the back and bottom straps
(Reference Step 20). Turn Booster Seat
over. Slide Strap Compartments open on
the bottom of the Booster Seat
(Fig. 21a).
• Fold the straps and put them in
the compartment, then slide the
Compartment Door closed (Fig. 21b).
15
Copyright © 2019, Baby Trend Inc., All Rights Reserved. Todos los derechos reservados. Tous droits réservés.
TO REATTACH SEAT PAD
22)
Fig. 20c
Fig. 20d
23)
Fig. 20e
TO REMOVE SEAT PAD
Reverse steps above.
Fig. 21a
Fig. 21b
• Thread non-buckle end of Harness
Straps called Harness Attachment
Tabs through the provided slots in
the Seat Fabric, Seat Back (Fig.
22a), and Seat Base (Fig. 22b).
When Harness Attachment Tabs are
through the provided slots, rotate
the Harness Attachment Tabs 90
degrees. Make sure that the straps
are firmly in place.
• Loop the flap on the back of the
pad over the top of the Seat Back
(Fig. 23a). Connect the Seat Pad
to the Seat Back with the two
Elastic Loops. These fit over the
Attachment Tabs located near the
top harness slots (Fig. 23b).
Fig. 23a
Copyright © 2019, Baby Trend Inc., All Rights Reserved. Todos los derechos reservados. Tous droits réservés.
OPERATION
Fig. 22a
Fig. 22b
Fig. 23b
16