Disposal And Recycling; Cleaning, Maintenance And Ordering Of Spare Parts - Toolson PRO-ST 85 K Manual De Instrucciones

Anleitung PRO_ST_85_K_SPK7:_
The best combination of speed and pendulum action
depends on the material you wish to saw. We
recommend that you always find the ideal setting
using a test cut on a piece of scrap material.
6.5 Laser (Fig. 12/Item 18)
The jigsaw has a laser (18) which projects the course
of the cut by means of a line on the workpiece. The
laser (18) can be switched on and off at the ON/OFF
switch for the laser (1).
6.6 Making cuts
Ensure that the ON/OFF switch (4) is not
depressed. Only then should you connect the
mains plug to a suitable socket.
Do not switch on the jigsaw until you have fitted
a saw blade.
Use only saw blades that are in perfect condition.
Replace blunt, bent or cracked saw blades
immediately.
Place the saw foot flat on the workpiece you wish
to saw. Switch on the jigsaw.
Allow the saw blade to accelerate until it reaches
full speed. Then slowly move the saw blade
along the cutting line. Only exert gentle pressure
on the saw blade as you do so.
When sawing through metal, the line of the cut
should be coated with a suitable coolant.
6.7 Sawing out sections (Figure 13)
Drill a large enough hole in the section you wish to
saw out. Insert the saw blade into this hole and start
to saw out the required section.
6.8 Making parallel cuts
Fit the parallel stop and adjust it accordingly (see
point 5.3).
Follow the instructions in point 6.6.
Complete the cut as shown in Figure 14.
6.9 Miter cuts
Adjust the appropriate angle on the soleplate
(see point 5.4).
Follow the instructions in point 6.6.
Complete the cut as shown in Figure 15.
7. Cleaning, maintenance and
ordering of spare parts
Always pull out the mains power plug before starting
any cleaning work.
30.03.2009 13:48 Uhr Seite 13
7.1 Cleaning
Keep all safety devices, air vents and the motor
housing free of dirt and dust as far as possible.
Wipe the equipment with a clean cloth or blow it
with compressed air at low pressure.
We recommend that you clean the device
immediately each time you have finished using it.
Clean the equipment regularly with a moist cloth
and some soft soap. Do not use cleaning agents
or solvents; these could attack the plastic parts of
the equipment. Ensure that no water can seep
into the device.
7.2 Carbon brushes
In case of excessive sparking, have the carbon
brushes checked only by a qualified electrician.
Important! The carbon brushes should not be rep
laced by anyone but a qualified electrician.
7.3 Maintenance
There are no parts inside the equipment which
require additional maintenance.
7.4 Ordering replacement parts:
Please quote the following data when ordering
replacement parts:
Type of machine
Article number of the machine
Identification number of the machine
Replacement part number of the part required
For our latest prices and information please go to
www.isc-gmbh.info

8. Disposal and recycling

The unit is supplied in packaging to prevent its being
damaged in transit. This packaging is raw material
and can therefore be reused or can be returned to
the raw material system.
The unit and its accessories are made of various
types of material, such as metal and plastic.
Defective components must be disposed of as
special waste. Ask your dealer or your local council.
GB
13