MZ electronic EV030-Radio Instrucciones De Uso página 22

then the instrument will scan 5 frequencies within the 868 – 870 MHz band. During this phase the display
will show:
when the instrument has identified the most suitable frequency it will connect to the power unit. The
address of the power unit will be shown on the display as follows:
if communication is successfully established the following page will appear:
Once the initialisation procedure is complete, the main page will appear.
Where:
STATUS: indicates the status of the instrument and any failure.
SPEED': indicates the chain speed during hoisting or lowering in meters per minute or feet per minute.
COUNT: indicates the measurement of the chain lowered (in metres or feet).
MONITORING: indicates the power supply voltage of the RX/TX power unit on the left side, power used
for transmission (minimum =1, medium =2, maximum =3) and the supply voltage of the radio chain
counter on the right side.
ICONS: this is the part of the display bearing the icons that indicate the hoisting or casting of the anchor
and any failure.
When the instrument is turned on for the first time, it will set up as programmed in the factory (see table).
EV030-Radio
STATUS
SPEED'
COUNT
MONITORING
Parameter
Up Alarm
Auto Down
Turnoff Time
Units of measurement
Chain Measure
Barbotin Circumference
Sensor type
Keyboard Beep
Language
Works Hours
Division Factor
Searching...
Connecting
to ID :
00001
Connection
established
on channel :1
Stop
0.0
0.0
f
[1]
V=11.6
V=12.4
Default value
3.0 metres
Off
30 seconds
Metres/centimetres
0.0 metres
33 cm
unknown
Yes
Italian
0
1
22
English
ICONS
metres / minute
feet / minute
metres / feet
Rev. 08 – 2019