Prior To Commissioning - Taski swingo 350E Manual Del Usuario

Prior to commissioning

Brush installation
Before inserting, please check:
• that the brush does not fall below the red marking (bristles)
or 1cm of bristle length.
• the pad for wear and cleanliness before use.
Attention:
Do not use brushes which have reached
their wear limit. The wear limit is indicated
by the length of the red bristle. Do not use
worn or contaminated pads. Use original
TASKI brushes only. Failure to observe
these instructions may result in inade-
quate cleaning results or even floor dam-
age.
• The machine must be switched off.
• Place the machine on the parking
support.
• Screw on the triangular handle (1)
1
and remove the brush holder (2).
2
• Insert the brush into the brush hous-
ing.
• Press the brush upwards with your
right hand so that it is accepted by
the centring hexagon in the brush
housing.
• Reattach the brush holder (1) and
2
screw the triangular handle (2) shut
again.
1
62
Squeegee assembly
• Lie the squeegee on the floor in front
of the machine.
• Tilt the machine towards the back
and run over the squeegee.
• Place the machine back on the floor.
• Set the locking nuts into the foreseen
slots.
• Turn the locking nuts 90°.
Filling the fresh water tank
Attention:
Max. permissible water temperature
60 °C/140 °F.
Diversey recommends using cold water
since hot water will adjust to the floor tem-
perature as soon as it is in contact with the
floor. Thus there are no advantages to us-
ing hot water.
• The machine must be switched off.
• Remove the rubber cap from the solution tank.
• Fill water into the solution tank until
the maximum filling level is reached.
10L
• Refit the rubber cap to the solution tank.
Dosing:
Attention:
Wear gloves, goggles and appropriate
(protective) working clothes when han-
dling chemical products!
Notice:
Use chemical products recommended by
Diversey only and always observe the
product information.
Caution:
Using unsuitable products (e.g. products
containing chlorine, acids or solvents) may
cause harm to health and severe damage
to the machine.