Safety suggestions
The electrical connection may be set up by suitably
trained and qualified, authorised personnel only.
Never work when voltage is present on the luminaire.
Caution - Risk of fatal injury!
Electrical connection
DADA
N L
...EDD
DADA
N L
...EDD
Please separately request Touch Dim-compatible Dali
luminaires (...EDD).
‚press to activate learn mode' button for teaching in and
teaching out of wall/hand transmitters (A)
L
TOUCH DIM RC
N
Ch1
out
Ch2
out
LED „learn mode active"(B)
16
Ch2
Ch1
N L
...+EOM
DADA
N L
...EDD
A
Learn
T1
T2
B
Start-up
Teaching in and teaching out of wall / hand transmitter
The transmitters must be taught in in the radio receiver of
the luminaire as follows:
•
Press and hold the ‚press to activate learn mode' button
with a suitable object (e.g. an insulated screwdriver) to
activate learn mode.
Confirmation: ‚learn mode active' LED (B) and lighting flash.
L
As long as the LED and lighting flash, up to 30 wall trans-
N
mitters can be taught in and taught out.
•
Press the button of the transmitter to be taught in or taught
out.
Wall transmitter: upper button.
4 The upper button operates channel 1, the lower button
automatically operates channel 2.
Hand transmitter: button 1 (or button 3).
4 Button 1 (button 3) operates channel 1,
button 2 (button 4) positioned below automatically
operates channel 2.
Confirmation:
- Teaching in: ‚learn mode active' LED and lighting light up
for 4 seconds, extinguish for a further 4 seconds and then
continue to flash.
- Teaching out: ‚learn mode active' LED and lighting extingu
ish for 4 seconds and then continue to flash.
Note:
In learn mode, sensitivity of the receiver module is reduced to
prevent adjacent transmitters from being unintentionally taught in.
If necessary bring the wall or hand transmitter nearer to the radio
receiver.
•
Press the ‚press to activate learn mode' button again to exit
learn mode. Learn mode is also automatically exited follow-
ing 30 seconds of inactivity.
17