How To Use - MSW BOH-1050-2 Manual De Instrucciones

HOW TO USE

1. Inserting and removing parts
The tool holder is maintenance-free. The dust cap prevents drilling dust from entering the machine during
operation.
Inserting tool:
Clean and lightly grease tool shank before inserting. Pull back fastening sleeve and hold. Twist the tool into
the holder and push it in until it engages. In case of BOH-1050-1 (6191), twist the tool into the holder and
push it in until it engages. It's not necessary to pull back the fastening sleeve. The tool shank locks in position
automatically. Pull the tool to check if it is locked correctly.
Removing the tool:
Push back the locking sleeve of the tool holder and remove the tool.
2. Handle attachment
For reasons of safety, the rotary hammer should only be used with the handle attachment.
3. Dust cap
Before carrying out hammer or drilling works vertically overhead, the device should be equipped with
the dust collecting cap.
4. 6042 – BOH-1800
1 – fastening sleeve
2 – cap for carbon brushes
3 – dust guard
4 – switch
- drill: "rotation is on" - to work with drills
- manual adjustment of the tool: setting the tool in the desired work position
- hammer: "rotation is off" - to work with cutters / chisels (tool position can be locked or unlocked)
Rev. 20.10.2016
17