Before First Time Use; Operating Instructions; Care And Cleaning - Nesco GWK-03D Manual De Usuario

1. Read and understand all instructions and keep for future reference.
2. Remove all packaging and labels.
3. Clean all parts, except Base, following 'Care and Cleaning ' section in this book.
CAUTION: KETTLE IS MADE OF GLASS, ALWAYS USE THE HANDLE FOR LIFTING
AND USE CARE WHEN USING OR CLEANING.
4. Wipe the Base with a damp cloth and dry thoroughly. WARNING: NEVER IMMERSE
THE BASE OR KETTLE IN WATER OR ANY OTHER LIQUID.
1. Unwrap cord and place base station on a sturdy and flat surface.
2. Open the kettle lid by pressing the lid release button located on the handle. Lid will
hinge open automatically.
3. Fill with cold water up to the desired level between the minimum and maximum
levels for the proper functioning.
• Do not overfill past the maximum level. Boiling water may spill out and cause
severe burn injury.
• Never fill the kettle with anything other than water, do not add instant soup or
use to heat any food.
4. Gently press lid down until locking into closed position.
5. Place kettle onto base station. Be sure kettle is securely placed, it should be flat and
center on base. If correct, connect cord to electrical outlet.
6. Gently press the ON/CANCEL button then press desired temperature setting.
7. When water reaches the set temperature the control button will begin to flash,
indicating the heating cycle is complete and will keep water warm for 30 minutes. If
select BOIL the kettle will cycle once and turn off.
8. Lift the kettle by the handle and slowly tilt to pour water from spout into cup.
9. Before disconnecting plug from electrical outlet, always turn off the kettle or lift
kettle from base station.
• Before disconnecting plug from electrical outlet, always turn off the kettle or lift kettle
from base station.
• Remove cord from electrcal outlet and make sure kettle has cooled before handling.
• Clean the base by wiping with clean, damp, cloth. Do not use abrasive cleaners or
scouring pads. Wipe dry.
• Rinse interior of kettle using clean water and gently wipe dry using lint-free cloth.
• Do not leave standing water in the kettle. Always discard unused water and dry
interior surfaces when not in use.
• To remove filter, open lid and lift tab on filter to inside. Filter will hinge, grasp with
fingers and gently remove.
• It is normal to see the stainless steel cover of the heater plate at the bottom of the
kettle to change color after use or if your water has high iron content brownish stains
may appear and can be removed with cloth and mild stain remover.
• Boiling water can leave behind harmless, white calcium deposits inside the kettle
and mainly on the stainless steel heater cover. Use a commercially available de-
calcifying agent or add 1 oz. vinegar to water, fill to minimum level and run BOIL cycle.
Hint: If the kettle switches off before water is reaches set point, it may need to be
decalcified. Frequency depends on hardness of water and number of uses.

Before first time use

Operating Instructions

Care and Cleaning Instructions
3