Identifying Warning Signals - SICE S 560 Manual De Instrucciones

ENGLISH • Instructions manual
- The power socket take is adeguately protected against over-
currents with fuses or circuit-breakers with rated values as
shown in the table below.
Note the required power draw as highlighted on the data plate fixed
to the tyre changer. Check to make sure the shop electric wiring
circuit is dimensioned sufficiently to carry this.
Work on the electric system, even if minor, must be done
exclusively by professionally qualified personnel.
Manufacturer shall not be liable for any injury to persons
or damage to property caused by failure to comply with
these regulations and can cancel warranty coverage.
TURNING DIRECTION CHECKS
Connect the machine to the mains, switch "ON" (5, fig. A) and check that the hy-
draulic power pack motor rotation corresponds to the indicating arrow (6, fig. A).
Otherwise, have an electrician switch two wires in the power supply plug.

7. IDENTIFYING WARNING SIGNALS

POWER SUPPLY
230V - 3Ph - 50/60Hz
400V - 3Ph - 50/60Hz
5
Danger:electric voltage presence.
Code 4-402353
Feet-crushing hazard during turntable turning
or opering
Hand-crushing hazard between turntable jaws.
Code 4-402638
Crushing hazard between turntable arm and
tyre changer body.
Code 4-402636
37
RATED CURRENT
FUSE SWITCH
40A AM 40A
25A AM 25A
6
A
S 560