Built-In Timer; Maintenance - ESPA evopool evopool SilenPlus ControlSystem Manual De Instrucciones

8. BUILT-IN TIMER

The SilenPlus pump has an internal clock that can
operate as a start and stop timer, making external
programming unnecessary.
With this function, SilenPlus can operate entirely inde-
pendently.
ATTENTION: the programming and mainte-
nance of the timer is only possible through the
EspaEvopool app.
8.1 Activating the timer.
DANGER. Electrocution risk.
Never open the SilenPlus cover without turning
the power supply off at least 5 minutes before-
hand.
• Lift the SilenPlus cover by loosening the 4 screws.
(See figure 5)
• Activate the Timer using the mini-switch, moving it
to the "ON" position.
• Replace the cover and fix it with the 4 screws.
Torque: 0.5 Nm.
8.2. Time setting.
Link SilenPlus with the external device using Bluetooth,
following the instructions on the device.
Run the EspaEvopool app and follow its indications.

9. MAINTENANCE

ControlSystem:
If ControlSystem is not communicating with SilenPlus it
may be necessary to replace the battery.
Proceed as in section 4.2.
It is a 1.5 V, CR2450 type battery.
SilenPlus:
Our SilenPlus equipment is maintenance free.
Clean the equipment with a damp cloth and without
using aggressive products.
In freezing weather, take the precaution of emp-
tying the pipes.
If the equipment is going to be inactive for a
long time, you are recommended to dismantle it
and keep it in a dry, well-ventilated place.
WARNING: in case of a breakdown, the equip-
ment must only be touched by an authorised
service technician.
The list of official technical services can be found at
www.espa.com.
When the time comes to throw the product away, it
does not contain any toxic or polluting material. The
main components are duly identified so you can dis-
pose of them selectively.
13
EN