Testing Of The Appliance - Angelo Po 1N1TPGV Manual De Uso

Important
Before it is put into service, the system must
be tested to check the operating conditions
of every single component and identify any
malfunctions. In this stage, it is important to
check that all health and safety requirements
have been complied with in full.
To test the system, make the following checks:
Check that the mains voltage is the same as
1)
that of the appliance.
Operate the appliance's circuit-breaker to
2)
check the electrical connection.
Turn on the gas supply tap and check that the
3)
connections are right.
Check that the mains gas is the same as that
4)
used for commissioning of the appliance,
and carry out the conversion procedure if
necessary (see page 12).
3320110_inst_GB_rev.1

TESTING OF THE APPLIANCE

Check that the plate, top and oven burners
5)
are lighting and burning correctly.
Check the gas pressure and fl ow-rate at
6)
minimum and maximum settings and adjust if
necessary (see page 6).
Check that the safety thermocouple is work-
7)
ing correctly.
Check that there are no gas leaks.
8)
Check that the nameplates specify the correct
9)
gas for the country of use.
After testing, if necessary instruct the user in all
the skills necessary for putting the appliance
into operation in conditions of safety, in accord-
ance with legal requirements.
- 13 -
GB
ENGLISH