Fault; Troubleshooting - Angelo Po 1N1TPGV Manual De Uso

The appliance has been tested before being
put into service. The information provided
below is intended to assist in the identifi cation
and correction of any anomalies and malfunc-
tions which might occur during use.
The user can solve some of these problems
himself, but for others specifi c technical knowl-
edge or skill is required, and so they must only
be carried out by qualifi ed staff with recog-
nised experience acquired in the specifi c sector
of operation.
Faults
Smell of gas
The pilot light does not
ignite
The pilot light goes out
The fl ame is yellow
Burner control knob is stiff
The burner does not light or
goes out suddenly
3320110_ut_GB_rev.1

FAULT

TROUBLESHOOTING

For all requirements contact the agents or
the headquarters of Angelo Po which can be
found in the contacts section of the website
http://www.angelopo.com.
Causes
Occasional leak because
fl ame has gone out
The spark ignition devices
are not working
Air in pipelines due to long
period out of use
The thermocouple has not
warmed up enough
Burner dirty, heat exchange
pipes clogged, condensation
drips
Gas control valve
malfunction
Oven safety thermostat
tripped
Thermocouple malfunction
Oven safety thermostat
malfunction.
- 15 -
Important
Remedies
Turn off the gas supply tap and
ventilate the room
Check that the ignition devices
are in good working order.
Light by hand with a naked light.
Important
Contact the after-sales service
Make more attempts to light the
fl ame
Make more attempts to light the
fl ame
Important
Contact the after-sales service
Important
Contact the after-sales service
Reset the safety thermostat (see
page 11); if the problem persists, call
the after-sales service.
Important
Contact the after-sales service
Important
Contact the after-sales service
GB
ENGLISH