Safety Thermostat - Tecnoinox FR Serie Manual De Instrucciones Para El Uso Y Manteniminto

Do not wash the appliance with jets of water because if
water gets into the electric components it could cause
the appliance and the safety systems to malfunction!
Models FRE and FRS have a safety thermostat that cuts off
the electric power supply in case of anomalies. To turn the
Malfunctions do not always depend on the quality of the
components used. These appliances are manufactured using
top quality components. Malfunctions may be caused by
voltage surges, or dust and dirt getting into the components.
In any case, if anomalies are noticed or suspected, turn the
appliance off and disconnect it from the mains. Call the
authorised repair service.
No particular maintenance is necessary other than normal
cleaning. The appliance should be checked once a year by a
Our appliances are studied and optimised, with lab tests, to
provide high performance and yields. However, to keep
energy consumption low (electricity, gas and water), we
suggest not using the appliance for any length of time if it is
empty or in conditions that compromise optimum yield.
All packaging materials are environment-friendly. They
can be kept without problem or burnt in a waste incinerator
plant. The plastic components that can be recycled are:
• Polyethylene: external packaging material and/or pluribol
film
• Polypropylene: straps
The Manufacturer declines any responsibility for damage caused by improper or incorrect installation or maintenance
Cleaning and care of the appliance

Safety Thermostat

Malfunctions
Maintenance
Ecology and environment
of the appliance, or failure to observe safety regulations!
GB / IE - 3
If the appliance is not going to be used for a long period
of time, disconnect it from the mains and clean it with
soapy water, rinse it off and dry it carefully. Spread a
thin layer of liquid paraffin on the surface.
The fryer must be cleaned every day with soapy water
and a liquid alkaline detergent.
appliance on again, press button "E". This must be done by a
specialised technician.
WARNING!
Unauthorised persons should never attempt to repair the
appliance, or carry out maintenance. Tampering with the
appliance voids the warranty!
repair service. For this purpose a maintenance contract
should be stipulated.
• Polystyrene foam: corner pieces, sheets and protection
blocks
At the end of the appliance's useful life, dispose of it
properly.
90% of each appliance is made of metal (stainless steel, iron,
aluminated sheet, etc.) hence it can be recycled by the
relative recycling organisations in compliance with the
standards in force in your country.
Prepare the appliance for disposal, so it cannot be used
any more, by removing the power cable and any locks so that
no one can get locked inside accidentally.
5410.251.02