ABAC 2809913622 Instrucciones De Uso Y Mantenimiento página 66

EN
Tire inflator
B
Before connecting accessories make sure the compressor is shut down.
Only use accessories and consumables that are designed for the use with this tool.
Select the best available inserted/mounted accessories/consumables for the lowest possible noise level and vibration.
Replace them in case of an increased noise level and/or vibration.
Make sure that the inserted/mounted tool/accessory is properly held by the retainer and make sure that the retainer
is in good condition. Never use the tool without a retainer as this may cause high speed projectiles.
Use the inserted/mounted accessory/tool according the manufacturer specifications.
Before start using the tool, make sure that you are familiar with the workplace and surrounding area.
Always obey the safety regulations for the work area you are working in.
During operating the tool, the operator may be exposed to hazards as crushing, impacts, heat, vibration, cuts,
abrasions, etc: Wear suitable gloves.
Any person handling the tool must be able to handle the size, weight and power of the tool.
Always be prepared for normal/abnormal movements/forces generated by the tool.
Keep your body in balance, place your feet safe and secure.
In case of interruption of the air supply, release the lever/trigger.
Connect the compressed air supply to fitting A. Connect the inflation fitting B to the valve of the wheel and check
the pressure on gauge C. Press the trigger D to inflate and keep checking the pressure on the gauge: if the pressure
is too high, press trigger D half-way to restore the correct pressure. To avoid damages to the pressure gauge do not
let the tire inflator fall on hard surfaces, in order to ensure a correct pressue value reading.
Use one of the adapters included into the kit (E) to inflate bikes inner tubes, balls or other devices. To avoid
damages to the pressure gauge do not let the tire inflator fall on hard surfaces, in order to ensure a correct pressue
value reading.
E
ACCESSORIES
USING A PNEUMATIC TOOL
USING THE TIRE INFLATOR
66
C
D
Fig.1
A