Triton 2000 Serie Instrucciones De Funcionamiento página 6

FITTING THE TRITON 235MM POWER SAW
Fitting the slide chassis
Place the Slide Chassis
(L) in the bearing
channels with the red
plastic catch and red
bearing spacers closest
to the front panel (the
switch box end) and the
flanges upwards. Enter
two bearings in the
channel cutouts. Slide
the chassis towards
the rear panel and the
other bearings will
drop in.
Spray the channels
with lubricating oil for a smooth slide.
Fitting the triton saw
Unplug your saw. Check that the blade is set
at 0° and at full depth of cut.
Fit the Saw Alignment
Cams (o) from below,
holding the bases in
the rectangular slots
while you screw into
them. (They cut their
own thread.) Make sure
the lines moulded on
top of the cams are
both pointing towards
the rear panel. Tighten
the screws until nipped
gently.
Fitting the saw locators and knobs
Fit the saw into the chassis with the alignment
cams locating in the holes in the saw base-
plate.
Break or cut the Saw Locators (k) and
GB
Clamping Knobs (l) from their moulding "tree"
and carefully trim off
any remnants with a
sharp knife. Fit the saw
locators in the slots
shown using 4 M6 x
40 screws (m) and M6
Fitting The Triton Saw
6
Flange nuts (n). The straight edges should be
against the baseplate, but spaced away from it
slightly to allow for final saw adjustment.
(Use a spatula blade or
a piece of cardboard or
metal about 1mm thick
as a spacer.) Firmly
tighten the screws.
Screw the knobs on
(they cut their own thread) until they just
scrape against the top edge of the saw base-
plate. This tension is sufficient to hold the
saw upside-down for
final adjustment, and
still allow the saw to be
shifted sideways slightly
using the alignment
cams.
Check that the saw is securely mounted.
Turn the slide chassis over, re-engaging the
bearings in the channels.
Aligning the saw
Position the chassis halfway between the end
panels. Adjust the fence in close to the blade
and lock it. Make sure
the blade is vertical
by comparing it to the
face of the fence. If
necessary, loosen the
nut holding the Blade
Angle Trimmer, and
adjust the blade angle.
Re-tighten the nut.
Use the saw's spanner
or the Tube Spanner (s)
to rotate the cams until
the front and rear of the