Descargar Imprimir esta página

Triton 2000 Serie Instrucciones De Funcionamiento página 7

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 45
blade are just touching
the fence, when it is at
0mm. When satisfied
with the position tighten
the alignment cam
screws.
Unscrew the front
handle of the saw for
better access to the
front cam. Lower the
blade for access to the
rear one.
Final clamping of saw
Double-check the saw position by now locking
the fence at 0mm, and trying to turn the
blade backwards by
hand. The teeth should
lightly scrape against
the face of the fence. If
not, repeat the above
alignment.
This is a very important step, because it will
ensure that your saw cuts are true, and that
your fence scales are accurate, so take your
time.
When satisfied with the position of the
saw,reposition the saw locators hard up
against the edge of the baseplate, as follows.
Hold each knob against
turning and loosen the
screw about half to
one turn. Push the saw
locator into position,
and firmly tighten the
screw.
Turn the saw right-way
up again and loosen the four knobs a couple
of turns. Check that the saw cannot move
sideways at all, and that all screws are fully
tightened. Do up the knobs again, perhaps
one turn beyond when they first scrape on the
baseplate.
The saw is now set up, and is available at any
time for hand-held use by simply loosening
each knob half a turn
and lifting the saw
straight up. If the
locators are correctly
fitted, the saw will go
back into exactly the
right spot each time.
Fitting the side guard
Slide the two sections of the Side Guard (K)
together until they fit between the pivot
brackets on the slide chassis. Loosely fit the
short M5 x 8 screw (i) and a M5 Nyloc nut (h)
to hold them together.
Fit the two longer M5
x 25 screws (j) and
M5 Nyloc nuts through
the pivot brackets and
into the guard flanges.
Tighten until the guard
is firm, but still free to
pivot. Finally, tighten
the screw holding the two halves together.
Fitting the trigger strap
Before fitting the Trigger Strap (q) always
ensure that the saw is disconnected
from the power and that the switch on
the Workcentre front panel is in the "OFF"
position.
Wrap the Trigger Strap (q) around the handgrip
with the furry side facing outwards. Pass the
strap through the buckle, until the security
loop has passed
through. If your saw
has a safety lock-out
button press it and then
tighten the strap until
the trigger clicks "ON".
Fitting The Triton Saw
GB
7

Publicidad

loading

Este manual también es adecuado para:

Wca201