Description And Use; Tools Needed For Assembly; Supplied Accessories; Installation - Vortice NORDIK ECO Manual De Instrucciones

Description and use

The product you have purchased is a reversible cei-
ling agitator fan unit with a maximum operating tem-
perature of 45°C.
NORDIK ECO series units have
been designed for household
use.

Tools needed for assembly

Figure A

Supplied accessories

Figure B

Installation

Figures: 4 ÷ 50
Please follow the instructions below for installation.
1. Make sure that the ceiling where the unit is to be
installed is structurally sound to support the weight
of the product.
2. Be careful that the anchoring devices do not com-
promise the structural resistance of the ceiling
where the unit is to be installed.
3. Use dowels that can ensure material stays gripped
to the ceiling where the unit is to be installed.

Operation

Caution!!! The information described in this chapter
only relates to use of the VORTICE Code 12829
POT-R regulator. Operation is possible with other
potentiometers provided they have the following cha-
racteristics:
1 - Resistive value 10kOhm
2 - Integrated or external switch
Fans are turned on by means of a switch integrated
into the potentiometer. Start from the stand-by posi-
tion on the knob and turn it clockwise. You will hear
a click when the switch closes and then, when the fan
is switched back on, you will hear a brief buzzer tone
accompanied by a quick ignition of the LED.
The speed setting is continuous. Up to about half the
potentiometer scale, product operation is on ventila-
tion; from half to full scale, it is in reverse. Fan passa-
ge to reverse is highlighted by two short buzzer tones
and two quick ignitions of the LED, while the reverse-
to-ventilation passage is highlighted by a brief buzzer
tone and a quick ignition of the LED (fig.51).
The area of hysteresis (fig.52) corresponds to the
maximum speed during operation in ventilation mode
and the minimum speed in reverse mode.
Shut-down occurs by completely rotating the knob in
the counter-clockwise direction. A long buzzer tone
and a long LED ignition will indicate shut-down.
The product can be remotely operated by means of
the VORTICE Code 21200 TELENORDIK ECO
remote control

Cleaning

Figures: 53 ÷ 55.
Before performing any cleaning or maintenance ope-
rations, turn the unit switch off and disconnect its
plug from the power supply.
Electrical connections
Figures: 56 ÷ 57

Dismantling caps

Figures: 58 ÷ 61 (rods 290÷915)
Figures: 62 ÷ 67 (rod 160)
ENGLISH
5