4. CONTROL
Function Buttons and Knobs
1
1. Ch1-24 input gain control knob The knob
Ch1-24 control the gain level of the channel's
input. Note: It is very important to properly
set the level of the input gain to minimize
noise and avoid overload distortion. When the
signal> + 18dB, this Clip LED lights green, in-
dicating the relevant channel signal overload.
When the signal> -30dB, this Sig LED lights
green, indicating the status of the relevant
channel input signal.
2. Control Room Knob This knob controls the
overall output level for control room.
3. Phones Knob This knob controls the overall
output level for headphones.
4. Route to Main Press the input channel but-
ton, then press this button, can quickly route
the input channel to main (including CH1-24,
AUX1-8 and FX1-2).
5. DC48V Phantom Power button Every micro-
phone input equips with an individual phantom
power which is controlled by the 48V phantom
power button. It will illuminate when phantom
power is activated. Note: Please notice that only
the condenser microphone needs phantom
power. Please do not supply phantom power to
any device which don't need phantom power
otherwise the device may be damaged.
6. Digital In/Out Press this button, it will switch
between Digital In and Digital Out function.
This button engages and disengages the digi-
tal channel when you have an optional input/
output module inserted.
P. 8
AUDIOLAB Live 24 XL -
English version
DC48V
•
Digital In: The button will illuminate to
indicate that current channel has been
selected as digital input. The window is as
below. For the detail operation, please re-
fer to introduction of DSP Control section.
•
Digital Out: The button will illuminate to
indicate that current channel has been
selected as digital output. The window is
as below. For the detail operation, please
refer to introduction of DSP Control
section. When the button illuminated,
please pay attention to which channel is
Digital Input and which channel is Digital
Output during operation.
Digital In
2
3