EcoFast FWD 380 Manual De Instrucciones página 17

Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 21
INSTALLATION
S
TEP
Recommendations
Before proceeding to install, check out:
- the condition of the sink drain line (especially
for the old and lead ones) by removing any
possible obstructions.
- the height of the kitchen wall drain.
D
ESCRIPTION OF ACTIVITY
Remove the sink drain (sink flange and waste trap) previously
installed;
Clean sink flange area of any putty or other debris;
Open the hinged clamp 6 and remove the sink flange 2;
Unscrew the mounting ring 5 and remove the flange cardboard
washer 4;
Insert the sink flange 2 and the flange rubber washer 3 into the
sink hole;
Tighten the mounting ring 5 together with the flange cardboard
washer up to the sink 4 then screw on with the relative screws
until the sink flange is seated tightly;
Check that the splashguard 7 has been installed on the disposer
8;
Wet the splashguard with water 7;
Insert the disposer 8 into the sink flange 2 by pushing upwards
(the disposer should hold up by itself);
Block the disposer with the hinged clamp 6;
Connect the discharge tube (12) as follows:
Thread the tube flange (10) on to the discharge tube (12);
Fit the tube rubber gasket (9) on to the rim of the discharge tube
(12);
Tighten the discharge tube (12) to the disposer (8) with the tube
flange screws;
RECOMMENDATIONS FOR WASTE TRAP INSTALLATION
Note: to improve the down flow of wastewater, the pipes of the waste
trap should be cut and deburred.
The discharge tube (12) of the disposer should be installed
perpendicularly to the three way element (15) in the central
position (A);
Join the goose neck (16) to the three way element (15);
Then, proceed with the union elbow for wall fitting (17) and the
wall coupling tube (19);
Service inlets:
The three way element (15) has , on either side, two service inlets
which may be used to connect wastewater from a dishwasher, or
a possible second sink bowl or an overflow;
Note:
8A the use of this inlet access, on the upper part of the disposer,
reduces the drain feature, therefore, it is highly recommended not
to connect any other electrical appliance to the disposer.
8A
this inlet access may be used to connect the overflow, by
using the corrugated and extensible pipe (21) provided.
To use the service inlet of the
disposer (8A) it is necessary to
remove the plastic plug as
shown in the figure on the right.
Remove loose knockout plug
from inside disposer.
Accessories, components or parts, are available from your
local dealer.
17
2

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Fwd 600Fwd 600 hs

Tabla de contenido