Putting The Machine Into Service; Important - Grillo G110 Manual De Instrucciones

Ist REVERSE
IInd REVERSE
IIIrd REVERSE
P.T.O.: independent from the gearbox, 965 rpm with engine at 3600 rpm.
Wheels: tyres 4.00-10, 5.00-10 (5.00-12 only with furrower and plough). Garden wheels 20×10.00-
8
Rotary tiller: 68 cm standard and adjustable up to 33-47-58-68 cm.
Handlebar: Side and height adjustment – reversible.
Track external measurements: with tyres 5.00-10 57 cm – with wide steel wheels 36-44 cm.
Implements and attachments: 110/115/117/127 central cutter bar, plough, furrower, driven trailer
150×110 cm, cage wheels, tow bar, all purpose flail 68-85 cm, rotary cutter 75 cm, snow thrower
70 cm, orientable brush 100 cm, orientable front blade 125 cm, power harrow 50 cm, rotary plough
30 cm, wheel snow chains.
1) Check that the machine has not been damaged during transport.
2) Fill with grease the machine PTO flanging all around the coupling (fig. 3 no. 20).
3) For transport reasons the machine is delivered with the handlebar in sickle-bar position
(handlebar over the engine). To turn the handlebar into the walking tractor position push the lever
downwards (fig. 3, no. 12) ant turn the handlebar of 180°clockwise. Do it slowly and pay attention
non to force the mechanism and not to damage the cables. Then insert the gear and PTO control
levers into the lower eyelets (fig. 3, no. 28). Also position the security device that prevents the
rotary tiller to work in reverse gear (fig. 2).
4) Mount wheels and implement (e.g. rotary tiller, plough etc.) and tighten the securing nuts
completely.
5) Add engine oil (please refer to the engine manual).
6) Add gearbox oil – fig. 6 (MP 80W 90 oil, or international equivalent API GL5 oil, US MIL-L-
2105D, quantity 2,2 litres for G85 and 1,9 litres for G85D and G107D.
7) Add oil into the air filter in oil bath (for versions provided with this type of filter), use the same oil
type as the engine oil (fig. 7A).
8) Insert the control levers into the lower eyelets (fig. 3 no. 28) if you use the machine in the
walking tractor version. If the machine is used in the sickle-bar version (handlebar positioned over
the engine) insert the control levers into the upper eylets (fig. 3, no. 29).
9) Verify the tyre pressure according to the table provided below:
4.00-10
5.00-10
5.00-12 (for ploughing only)
10) In the electric starting versions verify the battery voltage, it must not be lower than 12,5 V,
when required charge the battery, at 12,5 V on slow charge for 2 hours.

IMPORTANT!

During assembly take care not to get the polarity of the battery reversed.
11) Fill the tank with fuel using a funnel provided with a fine filter.
12)
Check liquid levels when the machine is horizontal.
Translation of the Original Instructions
Gears
Ist
IInd
IIIrd

PUTTING THE MACHINE INTO SERVICE

TYRE PRESSURE
2 PLY RATING
2 "
2 "
Speeds with tyres 5.00-10
"
"
9
1,3
2,4
5,0
0,7
1,5
3,2
1,1 BAR
1,5 "
1,5 "