Genesis GDP1012A Manual Del Operario página 7

UNPACKINg AND CONTENT
IMPOrTANT:
faulty or that a part is missing. If you find anything wrong, do not operate the tool until
the parts have been replaced or the fault has been rectified. Failure to do so could result
in serious personal injury.
CONTENTS IN PACKAGE: (FIG 2)
Item Description
A Head Assembly
B Table Assembly
C. Column & Support
D. Base
E. Spindle feed Handles
f 5/8" Chuck
G. operator's Manual (not shown)
H. Crank Handle
K
F
L
I
WArNINg:
the saw, plug in power cord or turn the switch on until the missing or damaged parts are
replaced.
ASSEMBLY
WArNINg:
switched off and unplugged from the power source
before adjusting, adding accessories, or checking a
function on the tool.
ATTACHING COLUMN TO BASE (FIG 3)
1. Set the Base (D) on a level, flat surface.
2. Place the Column & Support (C) on the Base (D), align the three
holes in the column support with the holes in the base.
3. Install a set of Bolts and Washers (N) in each column support
hole and tighten with a wrench.
Due to modern mass production techniques, it is unlikely the tool is
Q'TY
1
1
1
1
3
1
1
1
E
J
N
H
If any parts are missing or damaged, do not attempt to assemble
Always be sure that the tool is
Item Description
I. Chuck Key
J. Drift Key
K. Rack
L. Column Ring
M. Housing Cover Knob
N. Bolts and Washers
o. Allen Wrenches
M
C
O
FIG 3
C
D
Q'TY
1
1
1
1
1
3 Sets
2
A
B
D
FIG 2
N
7