Princess 2988 Instrucciones De Uso página 5

S = small (ready in approximately 8 minutes)
M = medium (ready in approximately 12 minutes)
L = large (ready in approximately 15 minutes)
After the START button (3) has been pushed, the machine begins with
preparation of the ice cubes in the selected size.
If the container is completely full of ice cubes the 'Ice-Full' (2) light will
come on. Take the container out of the appliance, store the ice cubes in a
cool place and put the container back into the appliance.
The Ice Cube Maker can be switched on again straight away to prepare a new batch of ice cubes. If there
is no more water, the 'Water Low' light (4) will come on. Fill the water reservoir with water and the press
the 'Start' button to continue the process.
If the ice cubes are left in the appliance they will gradually melt. The melt water will collect in the water
reservoir and then the ice cube maker will start to produce a new batch of ice cubes.
The machine can be stopped at any time by pushing the 'Stop' (5) button. When the Ice Cube Maker is not
being used for an extended period, empty the water out of the reservoir and unplug the appliance.
CLEANING
Before cleaning, unplug the appliance from the electrical outlet. You should use a damp cloth to clean
both the interior and exterior of the appliance. Do not use any abrasives or solvents to clean the appliance.
Do not clean the appliance with detergent, either.
Do not leave water in the machine for an extended period. The water may become contaminated. Use
the valve on the back of the appliance to remove any excess water. It is advisable to clean the machine
regularly with an anti-algae and anti-bacterial agent. Follow the instructions on the packaging.
On the rear of the ice-cube maker you will find a drainage hose that can be used to empty the appliance
(see illustration below). Remove the hose from its storage position and screw it onto the valve by first
unscrewing the valve cap. Drain the reservoir. Once it has emptied remove the hose and close the valve by
replacing the cap.
PRINCESS TIPS
- Do not place the Ice Cube Maker on its side or upside down. Especially watch out for this when
moving the appliance.
- Do not position the machine up against other appliances or a wall. The ventilation holes should never
be covered.
- Do not use the Ice Cube Maker outdoors.
- Never submerge the appliance in water or any other liquid, as this can cause electric
shock.
- Keep an eye on the Ice Cube Maker when within the reach of children. Of course be
careful yourself, as well.
- Unplug the appliance if you will not be using it for an extended period.
- Do not put the machine near heat sources.
- In case of damage to the appliance or its cord, we advise you to not use the device, but
to return it to the store for repair. Damaged cords can only be replaced by our service
department.
- Keep in mind that using parts which are not recommended by the manufacturer can be
dangerous.
5