Trilux Belviso S EDS Serie Instrucciones De Montaje página 17

Locking and releasing of push button functions
Button
long
min
darker 15 secs.
Locking of nominal value saving and deactivation of automatic
switch-on.
Dim the luminaire via pressing and holding to minimum
brightness, and after reaching this minimum value keep the
push button pressed for 15 secs.
The luminaire flashes as confirmation. Nominal value setting
and deactivation of automatic switch-on are now locked.
Button
long
max
lighter 15 secs.
Locking of manual dimming
Adjust the luminaire via pressing and holding to maximum
brightness and keep the push button pressed for 15 secs.
The luminaire flashes as confirmation. Manual dimming,
nominal value setting and deactivation of automatic switch-on
are now locked.
32
Button
long
30 secs.
Releasing all locked push button functions
Press and hold the push button for 30 seconds.
The luminaire flashes as confirmation. All push button func-
tions are now released again.
Troubleshooting
The luminaire is not functioning.
Possible reasons:
- The luminaire was switched off with the button.
Switch the luminaire on.
- No mains voltage.
Check whether the green LED lights up when moving your
hand in front of the sensor.
- The lamps are defective.
Contact with TRILUX is recommended with defective lamps.
- The sensor is exposed to too much ambient light.
Keep the sensor shut and observe the performance of the
luminaire.
33