Laser Safety; Fcc Radiation Exposure Statement; Fcc Warning - Proscenic LDS D500 Manual De Usuario

Questions
Cannot return to the charging base
after partial cleaning or being moved
to another position
If you can not connect robot to your phone, please refer to the following list for troubleshooting：
1.Please make sure that the WIFI password is entered correctly.
2.Please confirm whether the WIFI is 2.4G; If the home router is a dual-band router, please set the
SSID name of 2.4G and 5G separately.
3.Please close the 4G traffic when binding. And after binding successfully, open the 4G traffic again.
4.Please check if the router has MAC address filtering set, or if the number of assigned IP addresses is full.
5.Try to avoid network rush hours (18:00 to 23:00) for the first time binding.
6.Please contact customer service if it is still not bound successfully.

Laser Safety

The laser distance sensor of this product meets the standards for Class I Laser Products in IEC 60825 and will
not generate hazardous laser radiation.

FCC Radiation Exposure Statement

This equipment complies with FCC radiation exposure limits set forth for an uncontrolled
environment. This equipment should be installed and operated with minimum distance
20cm between the radiator & your body.

FCC Warning

This device complies with Part 15 of the FCC Rules. Operation is subject to the following
two conditions:
(1) This device may not cause harmful interference,
(2) this device must accept any interference received, including interference that may cause
undesired operation.
NOTE: Any changes or modifications to this unit not expressly approved by the party
responsible for compliance could void the user's authority to operate the equipment.
Solution
Please manually place the robot in the charging stand.
13