Flash Tube Replacement - Elinchrom Quadra Hybrid S/A Head 20139 Manual De Instrucciones

User Manual

FLASH TUBE REPLACEMENT

Elinchrom uses high quality long-life flash tubes specifically made for Quadra Hybrid A and S Heads. To exchange a
user replaceable plug-in flash tube, please follow the instructions below:
1. Switch the Ranger Quadra Power Pack OFF.
2. Disconnect the cable first from the RQ Power Pack and secondly from the RQ Head.
3. Place the RQ Head on a dry and clean surface.
EN
4. Wait until the RQ Head cooled down.
5. Attention: Use protective gloves to remove the flashtube:
• Pull the flash tube firmly out of the terminals.
• If the tube is broken, use security gloves. Avoid cutting yourself!
• Never touch the metal electrodes and ensure that the unit is discharged and disconnected from the RQ
Power Pack! Use an insulated tool to pull out the electrodes.
6. Take the new flash tube. A glove or "plastic protection" MUST BE USED.
• For the RQ S-Head use the S flash tube / N° 24087
• For the RQ A-Head use the A flash tube / N° 24086
7. Contact with your fingers on the glass, will cause dark markings on the tube when it is used.
8. Check that the tube is correctly aligned (central) and that the trigger contact is gripping the tube.
9. Re-connect and test the unit as usual.
Quadra Hybrid S Head
N° 20139
6
Quadra Hybrid A Head
N° 20134