ARIETE 1779 Manual De Instrucciones página 12

EN
- Cut the foods into small pieces and place them inside the bowl (D) or for mixing, insert the ingre-
dients.
- Fit the lid (E) over the bowl (D) moving the mark inside the bowl (D) so that it is in line with the
symbol ( ). Block the lid (E) so it clicks into place by moving it clockwise ( ) (Fig. 7).
- Plug the appliance into the mains power.
- Start the appliance, selecting the rotation speed of the blade using the operating dial (A).
The appliance is equipped with a control knob for adjusting the speed from a minimum to a maxi-
mum.
WARNING
When the appliance is used to for mixing or whipping-up, it is recommended to start with the lowest
speed and then increase the speed. When used to chop, it is advisable to use the pulse function,
turning the dial (A) anticlockwise to the "P" setting. For optimum use, press the button in short bursts
(2/3 sec.).
- For smoother, finer chopped foods, remove the food, if necessary, from the sides of the bowl with
a spatula, pushing it towards the centre.
- If it is necessary to add foods during appliance operation, use the opening in the lid (E). Push the
foods down with the pusher (F) on its own (Fig. 8).
- To stop the appliance, turn the dial (A) to "0".
Slicing
WARNING
The blades are sharp; handle with care.
- Fit the required blade, the slicing blade (P), julienne blade (O) or chip blade (Q) into the blade disc
(R) so that the hole in the blade is in the centre of the disc (Fig. 9).
- Fit the assembled blade support disc (r) on the motor shaft (C), gripping it by the relevant slots and
keeping the blade so it is facing upwards (Fig. 10).
- Fit the lid (E) over the bowl (D) and proceed as described in the section "Chopping, mixing or
whisking".
INSTRUCTIONS FOR BLENDER USE
- Fit the blender (I) onto the power base (B) and turn it clockwise until it clicks into place and so that
the tabs on the blender fit perfectly into the slots in the power base (Fig. 11).
- Fit the lid (H) onto the blender (I) and press it gently down until fully inserted (Fig. 12).
- Insert the foods (prepared previously) through the opening in the lid, without exceeding the maxi-
mum level, which is marked on the blender (I) and then insert the plug (G) into the lid (H) pressing
it gently downwards and turning it clockwise to lock it into place (Fig. 13).
Note: The plug (G) also has a measure.
- Switch on the appliance, selecting the blade rotation speed with the operating dial (A).
The appliance is equipped with a control knob for adjusting the speed from a minimum to a maxi-
mum.
It is also possible to select pulse operation by turning the dial (A) anticlockwise to "P". For the best
use of this function, only turn the dial for a very short time (2-3 sec.).
Note: For softer fruit and vegetables (e.g., bananas), start at slow speed and then increase the speed
- 10 -